Hartselle, AL, Heater Installation and Furnace Repair Services

Corbin’s Air, Water & Power Solutions, Inc has been heating homes in this part of Alabama since 1935, and our technicians handle heating repair Hartselle AL calls out of the Huntsville office on Whitesburg Drive. Search furnace repair near me Hartselle AL on a January evening and you will speak with a live dispatcher immediately, because no heat repair Hartselle, Alabama, requests do not wait for morning. Diagnostics come with a written price for your approval, replacement estimates are free, and we carry HVAC license #1992263 along with BBB membership. Decatur, Priceville, Falkville, Somerville and the rest of Morgan County are covered by the same crews.

Winter in this region is deceptive. Most of the season is mild enough that furnaces and heat pumps idle along, then a cold snap drops temperatures into the teens for three days and every weak component in the county fails at once. Homes near the Downtown Hartselle Historic District often heat with gas furnaces in tight basements or closets, some venting through original chimneys. Newer neighborhoods along the US 31 corridor lean heavily on heat pumps with electric auxiliary strips, which behave very differently when the outdoor temperature falls below the balance point.

Not sure whether you have a furnace or a heat pump problem? Our Heating page explains the repair, maintenance, and installation work our licensed technicians perform for Hartselle households.

No Heat on the Coldest Hartselle, AL Night of the Year

A no heat emergency service call in a hard freeze is about more than comfort. Interior temperatures falling into the 40s put supply lines in exterior walls and crawlspaces at risk, so one problem becomes two.

Check these before we arrive:

• The thermostat is set to heat and calling, with fresh batteries
• The furnace filter is not completely loaded
• The furnace switch on the wall or unit has not been flipped off
• The breaker for the air handler or furnace has not tripped
• The gas valve at the appliance is open

If those look right, the fault is internal. Our technician will read the control board diagnostics, test the ignition sequence, and measure gas pressure or refrigerant pressures depending on the equipment.